How to solve the problem of slurry pump blockage?How can we solve the problem of blockage found in use?Many customers think that this is a very complex problem, but if this kind of congestion problem is not handled well, it is easy to cause damage to the equipment, thus affecting the efficiency of use, so we should pay special attention to, so in fact, if grasp the following points can easily solve the problem.
(1) solid sediments in the vortex shell of horizontal slurry pump make it silted up, and measures to remove silt can be taken.
(2) if the shaft and the feeding box are different from each other, the main reason is that the machining error is large and the installation is incorrect.Attention should be paid to check whether the installation is correct after installation.If the sealing water ring is badly worn, a new water ring should be replaced.If the sealing water pipe is blocked, the sealing water cannot get into the middle of the packing roots, resulting in quick wear and tear of the packing roots and material leakage.Dredge the blocked pipe and keep the sealing water clean.
(3) if impeller or inlet and outlet pipe are blocked, impeller or pipe can be cleaned.If the impeller wear seriously, it should be replaced.If air leakage occurs in the packing port, the packing shall be compacted.If the conveying height is too high, the loss resistance in the pipe is too large, and the conveying height or resistance is reduced.
Horizontal slurry pump should be used regularly for its maintenance work, including desilting, so as to effectively avoid the problem of slurry pump blockage.When dealing with this kind of problem, different ways can be chosen according to the specific situation of congestion.